Skip to main content
Skip table of contents

Hyperion3

The Hyperion3 LiDAR module is part of the CountryMapper system.

Gated vs Ungated Mode

Hyperion3 sensors can be operated in Ungated mode.

  • Ungated Mode: In ungated mode, data is collected without restrictions and the correct MPiA zone for every point is determined during ingest. The algorithm for determining the correct zone will use multiple zones above/below neighboring points. If data was collected using a high pulse repetition frequency (PRF) the resulting zones will be very small. It can therefore happen that even though HxMap evaluates multiple zones, the point might be located outside the evaluation window. In cities where large elevation jumps (e.g. skyriser buildings) are expected, it is therefore recommended to lower the PRF during acquisition which will extend the evaluation window (as all individual zones will become bigger)

Scan Pattern

Hyperion3 sensors use a circular scan pattern and operate in a constant PRF mode, this means that the resulting point density at the edge of the strip will be higher than the center of the strip. This is because the sensor movement at the edge is along flight direction while in the center it is across flight direction. In case a constant point density is desired, the decimation filter can be activated in LiDAR product generation.

Sensor Misalignment Pattern

Lines for misalignment calibration

  • Double cross flown at 2000 meters AGL, 4 total strips

  • Each line of the cross flown twice, in opposite directions

  • One direction in flower mode, and the opposite direction in circle mode

  • Pulse and scan rates as shown in the table, all lines are flown in gated mode

  • Differential GNSS with baseline < 30km

Direction

Scan Pattern

PRF (kHz)

Scan Rate (Hz)

SNR

Threshold

N → S or S → N

Circular

AutoAdjust
(~400-500)

AutoAdjust
(~70-80)

12

150

Opposite to above

Flower

AutoAdjust
(~400-500)

AutoAdjust
(~150)

7.1

150

E → W or W → E

Circular

AutoAdjust
(~400-500)

AutoAdjust
(~70-80)

12

150

Opposite to above

Flower

AutoAdjust
(~400-500)

AutoAdjust
(~150)

7.1

150

All lines flown at 2000m AGL, 40deg FOV, 5-10km line length, in gated mode and with 6-7 MPiA zones

Lines for verification

  • Flown in same mission as estimation lines

  • Single line at 2000 meters AGL, 2 total strips

  • The line is flown twice, in opposite directions with a side overlap >20%

  • Both directions in circle mode

  • Pulse and scan rates as shown in the table, either gated or gateless

  • Lines from real project are also OK if they are flown after the cross

Using gated mode:

Direction

Scan Pattern

PRF (kHz)

Scan Rate (Hz)

SNR

Threshold

N → S or S → N

Circular

AutoAdjust
(~400-500)

AutoAdjust
(~70-80)

12

150

Opposite to above

Circular

AutoAdjust
(~400-500)

AutoAdjust
(~150)

12

150

All lines flown at 2000m AGL, 40deg FOV, 5-10km line length, in gated mode and with 6-7 MPiA zones

Using ungated mode:

Direction

Scan Pattern

PRF (kHz)

Scan Rate (Hz)

SNR

Threshold

N → S or S → N

Circular

AutoAdjust
(~1000-2000)

AutoAdjust
(max.)

12

150

Opposite to above

Circular

AutoAdjust
(~1000-2000)

AutoAdjust
(max.)

12

150

All lines flown at 2000m AGL, 40deg FOV, 5-10km line length, in ungated mode

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.