Leica FlightPro 6.4.0 Release Notes

Release Systems

• Leica TerrainMapper-3 with MFC250 Camera

Main features

• Support for Leica TerrainMapper-3 with MFC250 Camera systems

  • Flight plans for Leica TerrainMapper-3 with MFC250 Camera systems must be planned with Leica MissionPro 12.15.1 or greater.

Main fixes

• Flight Guidance: Fixed issue where the Inline view had quick lateral deviations

• FlightPro: Warning messages were not displayed when missing the IP of a flight

• FlightPro: Fixed issue where the database was not available at startup

• GNSS/IMU: Improved GNSS/IMU performance

• GNSS/IMU: Handles filtered Satellite selection correctly in configuration

• GNSS/IMU: Fixed the wrong PAV heading values when the real-time trajectory status changes

• Simulator: Fixed issue in simulation with too high wind speed value

• Simulation: Disabled the CPU cores check

Main Changes

• Configuration: Show additional Sun Angle Information is disabled for new FlightPro installations

• GNSS/IMU: Updated the list of IMU types

• Interface: Roll, Pitch and Drift angles of aircraft during flight line recording

  • The GNSS/IMU control shows Roll, Pitch and Drift angles of the aircraft, in degrees with a coloured- background. From FlightPro 6.4.0, the coloured background is only active when the system is recording on a flight line.

• Interface: Display of System and Recording Types

  • The system type [system type] is now displayed in Main Menu as Leica FlightPro for [system]. If FlightPro was set to a mode where all the cameras or the LiDAR Unit is disabled then the active components are listed in addition:

    • Leica FlightPro for [system] (Camera Only)

    • Leica FlightPro for [system] (Lidar only)

• Interface: Removed Active Camera Heads configuration option

• Interface: Improved texts for error and warning messages

• Performance: Operator and pilot can’t select or use the 3D navigation views on an OC60 Operator Console

Known Issues

• MM30: Formatting of MM30 Mass Memory 7680GB M2 with FlightPro takes nearly an hour on some systems with older software

Upgrade Notes

• Recommended upgrade steps are:

  • Leica FlightPro 6.3.0

Licensing

Leica FlightPro 6.4.0 requires a license file with version 6.40 licenses.

Workflow requirements